Search results

hi does any know the best way of refilling the coolant on one of these machines as it constantly comes up with the error "low coolant" Cheers

thanks coloured I played with it the other day again and came to that conclusion what had me worried initially was that in the instruction manual it states old monitor runs on 220V "new monitor runs on 5V OR 24V" but you actually need to connect both!!! there was the confusion did not want to...

has this issue been resolved few questions was it working before de install who installed it and why didn't they test it during commissioning what type of pressure intensifier does it have? is it mounted up under the machine or is it sitting on the floor

yes I do have the instructions so you need to connect the 5v and 24v and how do you test the voltage at the plug once connected to the cu board

hi all I purchased a polar monitor retrofit kit for my 115 em I have put in the new monitor and cables also a new graphics card what is confusing me is the 5v or 24 v connections do you connect both ?? and where does the minus voltage come in to it

the suction plate near the side lay that pulls the sheet across can become clogged with spray and paper dust can cause all sorts of feeding issues

has this been resolved

eak2-11 when that screen comes up on boot up it means that some of the pushbutton globes are not working on the feeder check which aren't working and replace screen should not come back