Recent Activity
Activity stream for all registered members at Color Printing Forum.
-
OkiTech posted a new thread.
Plockmatic Pro50 Bookletmaker with FaceTrim & SquareBack in NJ
Hi. Thank you for visiting my listing. I have just received terrific Plockmatic Pro50 Bookletmaker equipped with Trimmer and Squareback...
Forum: Finishing Equipment for sale
May 8, 2024 at 11:08 PM -
hiustw attached a file to the thread R700 problem.
I always thought I needed to observe the indicator light of the LA8 solenoid valve because it seemed to be functioning normally when...
May 8, 2024 at 8:38 PM -
hiustw attached a file to the thread R700 problem.
Delivery,chains lubrication system;pile travel monitor Can you help me identify which indicator light it is? I've taken a photo
May 8, 2024 at 8:35 PM -
drukman attached a file to the thread R700 problem.
Which of these electrical schemes should I help you with? These are the series up to 2008-10. ... and they are not the same.
May 8, 2024 at 6:08 PM -
drukman attached a file to the thread Eccentric wrench.
I can send you a few, but you won't like the shipping cost. Make them yourself. I made a sketch for you today. When you understand that...
May 8, 2024 at 5:46 PM -
B1printer replied to the thread R700 problem.
Eliminate the electronics and press ? on the electronic information of the fault point to view more specific electrical number information.
May 8, 2024 at 8:36 AM -
Chris86 replied to the thread A CPC-COM error.
Hi, i will let you know. my buddy reconnected just the BEK and for now its ok. Next thing i said to him is replacing that cable you...
May 8, 2024 at 7:26 AM -
Asim Shehzad replied to the thread R700 problem.
if you read only slot 5 then input 3.0
May 8, 2024 at 5:16 AM -
Asim Shehzad replied to the thread R700 problem.
SPS rack A350 slot 5 input 9.0
May 8, 2024 at 5:15 AM -
th5743 attached a file to the thread Eccentric wrench.
I need tools used to adjust the plate.
May 7, 2024 at 9:49 PM -
hiustw replied to the thread R700 problem.
my machine is 2002 R705+LV.
May 7, 2024 at 9:08 PM -
CHOCK replied to the thread Error 15-01 on Heidelberg Printmaster 46-2 (Also Quickmaster).
Hi sir: this error coming for : MRK error messages: Crank handle operation (> 75 r .p.h.); r Hardware error, i.e. parts defective...
May 7, 2024 at 8:52 PM -
drukman replied to the thread R700 problem.
Until you write the SERIES of the machine, you won't get a serious answer.
May 7, 2024 at 7:52 PM -
Adil replied to the thread Eccentric wrench.
How many part you need ??
May 7, 2024 at 7:43 PM -
drukman replied to the thread Eccentric wrench.
Improperly adjusted flaps. Adjust it.
May 7, 2024 at 7:37 PM