I have swapped developer M with C. Can confirm that faded corner left at the same spot with Cyan developer. So I think left to try swap rollers...
Ok, so I have cleaned the ROS from inside, both for CK and MY, all mirrors, windows etc. Only find dust on the outside windows a little bit, means...
when changed transfer belt, cleaned all rollers. I can see density issues only on magenta. I made a few test prints with 20% and 50% coverage...
did you had the same issue with lighter side of the print? Machine has 800k clicks, I have bought it on 700k clicks and this problem was there, so...
Hello all, would like your help and opinion - what cause lower density on the SRA print on the side which is near open doors of machine (front)?...
Hello, Would like to ask you some advice about cutting stack of fully printed papers with printed bleeds. The problem is that back of the paper...
Hi, I have problem with different colors on second side of paper. I print from bypass tray manually on both sides coated 280 gsm paper (paper is...
I would like to know if i could adjust clamp pressure (binds 3-4 pages on top of coated paper, specially if it fully printed), also there is other...
I have changed the blade to new and the problem is gone. The old one knife was 82 mm width (recommended minimum 83 mm). I think it was too short...
Thank you for the hints, machine has made ~1.3 mln clicks and I dont know the maintanance history. I've got it used and started to rebuild for...
wanted to ask also - how to get as much as possible consistent color coverage on print media? What should i change and where to look for a...
2nd btr was the problem, thank you
