Do you have a 400 booklet maker? Yes mechanically you can move the motor. Code 11 is the high voltage running through the cover switches that gets...
Did you happen to get the booklet maker running I went by a machine the other day and I recorded where the switches should be.
How are you doing?? maybe have to go a bit deeper in the controls
Remove the black cable and see. If you lift up the trimmer cover and it doesn't say error on the staple unit it is definitely not communicating...
Ok my customer says Stapler switch up Trimmer up Combo switch down These are the ones on the side of machine
So maybe the first question is this machine new to you or has it been running and all of a sudden started this problem? A couple more simple ones...
Oh the cables. Blue internet cable out of stapler #2 into trim #1. Black cable same. Out of 2 into 1 When it's correct and you power on, green...
This is the way it should work. Some of these switches are up and some down. I'm trying to remember the correct position. Flick top cover switch...
Make sure your communication settings are correct. If you open it's cover does stapler show error? When you start stapler unit trim should start...
Ok 2 beeps. Press lower left key like a diamond. It should run 1 set then you check order and sheet quantity. If ok enter count press go.
How many beeps? The number of beeps means something. Did you clear the count when you start a new job? Then press the reset/calibrate key
When you open and close or remove covers it cuts the power to the machine as a safety by going through what they call the RL board. This board is...
Did you fix it? Where is this code 11? If it's on the booklet maker it usually means one of the cover switches is not activated and therefore...
Go into options all the way to the end. See detection? Shut off that bin. See what happens. Or take out the sensor and switch with another bin....
Yes that's what it does. When you start it should raise up and run
