Manually pull brake handle and and try inching press. Maybe brake discs are worn or fouled.
There is, as you can use the opposite high side of the eccentric bolt #17. The locking set screw is difficult to get to, you must either remove...
Sounds like your overrunning clutch(es) are bad. Check catch pan under pan roller gearing (under gear side main cover) for metal shards.
“Just Do It”...as is said. Use new roll in to drive out old. The only problem you may run into is if the old pin is fully cracked/broken and...
How about this? If the “pins that are designed to break” are simply roll (or spring) pins, is it possible to figure out the proper dimension...
Read my post.
Pressparts LLC, Demers Parts
Since you say the pile moved up slowly initially, and then you went down (any obvious change in down mode?), now won’t go back up, leads me to...
Are you certain it’s a pump issue?
To acquire the measurement, you’ll need a vernier caliper. Shall we proceed with the procedure?
Is the press clearing the feedboard, not leaving a sheet at the headstops?
Yes. You’ve had no formal training on this machine, have you? Good luck
Lit is on.
Radial valve in suction head.
OK, given the fact you have proven electronic cards and relays are doing their job, I do recall years ago an instance where the “mother board”...