Recent content by Ndirangu

Thanks, guys I managed to sort out the problem and the Polar 115 guillotine is up and running.

Please find attached photos for your information.

Thank you very much for your response to this issue. This is an old Polar-Mohr Standard 115 as per the attached photos and the cable from behind is connected to the small PCB board on the right side of the machine. As from of the front on the PCB the only writing on that connector is 3, 6, 4 as...

Good morning guys, there is a cable that I found lose behind our Polar - Mohr Standard 115 and it seems to have come out from the transfomer but I could not identify from which pins it came from. Please assist from the attached photos as the transformer is well labled. Thanks for your continued...

Thanks, guys the formula worked and I removed the pulley and I removed the hydraulic pump and I replaced the front seal on the pump and reassembled the pump but I noticed a small gap at the back cover(1mm) and this baffled me as I counter reassembled the pump three times as I personally have...

Good morning Guys, We have the above guillotine and the oil is leaking on the hydraulic pump seal on the lower pulley. I remove the center bolt and the three bolts on the pulley and the half piece of the pulley came off and I found out that the other half pulley is secured by another screw kind...