I see this is an old post - I was getting error issues ( nothing would work ) and found the spinner was not spinning - on the left side attached...
I did this for my Hamada 234 Give operator a plate with a line from top to bottom (length wise) - run an 18 inch sheet ( or as long of length...
I would double check the plate material is for a DPM ( laser imaged ) - not for a camera platemaker
figured it out Thanks for the reply guys - I figured it out - the reason why 108 has no reference in the Hamada manuel is because the 108 code...
Hello, Getting a 108 error code on a H234 - can't find reference to that number as to where issue is - has been intermittent - but tripping...