Recent content by mcsongor

dismantle both sides carefully everything is in your way......take out old anilox.....place in new anilox....assemble everything back in original position...check nip width...enjoy printing...

If paper streching is you problem maybe you should change paper grain direction

gluing should be the second step if laminating and UV is possible at that thickness,or die cut for centre and holes has to be the last step, but make sure overlapping the white is perfect

since overlapping of two sheets is not perfect ,die cut can't be neither...

first check if com port configurations are ok

Also might be clogged thread...check ,clean,grease.Fine adjustment is possible changing sensor position but not recommended

deacivating the side lay from the console you are able to move it by hand with a knob fitting on that hole near that small gear

E17 is overrun error.The home position sensor should stop the side lay preventing this to happen.

first make a visual check...photocells must be lit ,clean of dust then manually insert a sheeet of paper covering photocells and with a non coductive (plastic) screwdrive set sensitivity (from white potentiometer )individually, following the red-green leds indication

take some good pictures and upload

That is condensation ....reduce difference of temperature between press and ambient

which model of Varicam you have?

Conventional UV; High power consumption High heat output Wider range of UV light 200 - 400nm wavelength High press speeds Requires external cooling, air or water. Lamp life about 1000 hours Wide range of ink's, varnish's and coating's Creates ozone Hazardous light output, must be shielded Must...

one option would be getting through impression your paper stock before print

air cylinder sensor ,problem solved...thank you