From what i heard at 2025 they will stop support of 5500 so...think upon it
If you print on difficult substrates Indigo is the best imho but 500-1000 prints -by prints you mean sheets i presume- its not worth it
Also open scorotron and check wire and bobbin.
Try out with new IO and new inks
You could alter recipe with higher trans white so you can go heavier on ink. Dunno just a thought.
Bleh missed the parallel to long side. A better photo would helped faster
Well if not then exchange BID or try a new one. Had a similar problem close to yours and it was BID
PIP and impression drum gears clean and lubricated?
Couldnt you make a hole at foil -meaning trap of white on foil- so white prints on paper?
Merry Xmas to all!
The dial you turn is for impression ONLY. Plate and blanket is FIXED from factory and not to be tampered with! Take the 0.35 mm filler and put it...
You want to measure the bearer rings if they are worn out?
What junker said
Thoughts: 1.Could you change grain? -short to long and vice versa- 2.Magenta dots look ok 3.Exchange order Cyan and Magenta 4.Do you use Super...
There is an option that forces printing on same PIP side for each seperation try that.