Recent content by freestyle printing

oh p.s. the water tray has neopreem as an insulator...on the bottom and sides.

thanks for the reply yes water is chilled but the rel. humd. is below 23% and seems to leak the same from 50% to 20% It seem to be flooding over the edges of the squeegees, as if the water height is too high in the center of the meter/chrome area. All (metering, fuzzy, and forms have been...

we have a 3302 H, it has leaked water around the damping system since day one and nobody has ever been able to tell me where the water is coming from. the side squeegees are replaced all the time and still drips and washes out the image for 25 or so copies,then prints good then drips again...

thanks for the feed back, we have taken out the tray and cleaned it and wiped off the foam squeegees, i have replaced the metering and the water form regularly? I even made drip catchers under the sides of the squeegees. Still leaks somewhere???

we have a 3302 H, it has leaked water around the damping system since day one and nobody has ever been able to tell me where the water is coming from. the side squeegees are replaced all the time and still drips and washes out the image for 25 or so copies,then prints good then drips again...