Recent content by e.ezeano

Yes the ink key electronics is divided into 3 groups and are connected to the upper rack boards via ribbon cables.

Hi. I am sorry, I don't understand your point. Please explain further.

Hi. Few days ago, we discovered that our CPC-01 ink keys (1-20) display area stays off even after the unit is on. The curious thing is that the part of the CPC-01 that handles the registration and the rotation of the ink fountain (steel) roller are working fine. Even the keys for selecting...

Smyth No12 manual Yes, I finally got the manual. I bought it from an American printer parts store. You may email them at barb@ppsnj.com. I'm sure they will get you the manual. Pls contact me if you require further assistance

I think you should use the mistakingly wound plate as the new supply roll by changing the gear stud at the appropriate side. With this method, there is no need to cut the plate and use the stencil. You only need to watch out for when the roll reaches the imaged are, then you can cut the plate...

hi guys, Error 15-05 shows up when I press SF 56 on my Classic DI. The operators manual attributes this problem to "No pulse signals from the press speedometer". What device controls the press speedometer and how can I possibily fix the problem. Any help will be highly appreciated...

That's a very useful information Paul. Thanks Finding DOS 6.22 has been a major headache. I found two imperfect ones with bad sectors, at least one was able to boot the computer. Interestingly, I was able to see drive C: and D:, the directories looked intact. Infact I ran scandisk from...

Thanks again Paul. Please do you know the version of DOS it is running?

Thanks Paul. I tried all the 3.5" diskettes that I found and none could boot the system. I fixed an IDE harddisk formatted with Windows XP and I got an error message "Error loading operating system". Perharps because it expects Windows NT 4 operating system. Don't you think this confirms...

On powering up the DI classic press, I discover that the computer hangs after it displays the following boot up messages: 7808 KB Ram test... Ok SCSI BIOS Installed Successfully! Power Management/APM Disabled 256KB Cach Memory 90 MHZ Single Processor System Could this mean a hard disk...

Yes the manual brake is applied while the press is running. If we move our foot from the manual break, the press stops. We now run the press like a sewing machine! I've checked the fuses on the TTK and they're okay.

Hi Guys Please I need your urgent prescription to the problem below: When I try to inch or run, the main drive does not turn after the safety warning sound. I eventually traced the fault to the drive brake. Apparently, the brake is not released when it should. If I apply the manual...