Hello I am having an issue with my 3302 while printing tower 2 will not duct ink in auto if I select manual it ducts though. Any help would be...
Good call Yorkshire !! problem solved !! Thanx very much
I will check that thanks
Water is hard from the source but goes through a DI filter and enters into technotrans at 500 my font is at 2700 conductivity and as far as...
Hello having some plate issues on my lithrone 6/28 noticed lots of spots on sheet in non image area in black also a band of more concentrated...
sorry yes they are near the impression cylinder some times oil will get inside. I just pulled the plunger out and cleaned with alcohol good as gold
On the op side frame there are two, one for each unit
The impression light flickers occasionally when I run uncoated or dull stock but does not light up at all on this dark stock and yes it runs with...
Tried that, still no dice
hello I am trying to print a job on duplex stock, white one side dark blue on the other. The press starts up, takes a few sheets into the press...
Did that turns out it was a sticky solenoid thnx though
hello hope someone has had this problem and can help, basically the press stays on impression when the paper feed is stopped. it is the second...