I might not be of much help however I had run a qmdi press years ago. If I am not mistaken the problem came from the rollers. I use to shim the...
Kompac or crestline units are always nice to have , however there is another option available, usually less expensive which may hold you over...
have you tested the sensor to see if it is going bad ? most sensors tend to give abnormal response prior completely going out , at least through...
Many years ago, I run a Komori Kony. The eyekoms on that press were bad about the plug in coming loose. Sometimes oil and grease would fall on...
If you look at the plate with an eyeglass you can see the dots. if the dot pattern is crisp and clear , the problem is pressure . if it is the...
Just a note for anyone trying this, it is extremely difficult if the roll is already perforated. as banjoman stated the blanket pulls stock...
Yes , in many cases ink with paper more than ink with printer. Each printer lays down ink differently. Unfortunatly when ever going to compatable...
not all inks are the same. not all paper is the same. the chemistry is different in coatings on the paper. I would call up Epson first and ask for...
Check pressure between plate and blanket , also check between blanket and impression.
many printing companies rotate machinery between 5 - 10 years of service. If you are looking to keep the machine for any length of time, you might...
Everyone has made great points on this issue, I have seen all of them. It may be a pain in the rear, but you'll have to clean everywhere and...
I tend to use a coat of grease over the bearings to help protect them from the chemicals so they last a while longer. If possible use roller...
I have used Syntac rollers for years. they are cheap but we do replace them more often than a higher quality roller. I have noticed owners grumble...
Hamada presses are still around in many small shops. That should tell you something about Hamada presses.
Jason, you are on track with a Hamada , Ryobi would also be a good choice. The Polar or Challenge cutters would also be a good choice. these would...