use the CPL service tools disk for auto calibration
what do you want to do with rodimo?
I think the interface module is not working with Lenze E82EV751_4B as shown in the picture, different switch positions have different baud rate...
clean the detectors and adjust them accordingly
if the coating supply and return pumps are working normally and you have the coating or UV in chamber blades and still have the level too low then...
yes hand terminal and temu are the programs for the control of ink slides via laptop
yes, possibly cable damage or a loose plug also the backplane board you need to test it by swapping to another station.
safety relay board slot 2 in the delivery station and the board where the run commands are mounted.
K050 should not de-energize until the machine stops normally when you pressed the safe stop button. so, for me, the auxiliary contacts of the main...
hello you mentioned K050 has 2 N.C but I think it has N.O contact used, please check it again
yes, you can ask about any problem. +923496630209
you are welcome
yes you can if your machine has the interfacing board (Vilma) you can replace the lust with Lenze vector 8200 and if no Vilma is available, you...
hello, check the k3 relay in A566 if it's working fine then check the k3 of the baumuller BKF12 drive and if your machine has simoreg then K1.
