Recent content by Andy muller10

Hello Dear fellows, Joe and Junker I agree with you friends, I as an electronic technician who earns money from technical support. But I would like to say most of participated people here in this forum, are the valuable Senior Electronic Engineers/Technicians, and the owners of printing halls...

Hello Joe As you have seen, this thread would be a good informative thread and could be a good reference for the the others who may be faced with this problem any how. in the other word: this is the thing that all Heidelberg users should know and how to handle the problem. So hereby very kindly...

Yes, Very welcome

Hello Mathew, Again I would like to express my best gratitude to you for your kind effort. I am sure the world would be a better place with the people such as you, buddy. Good Luck Regards

Hello Mathew Thank you very much in advance. My friend. andy.muller10 AT yahoo.com Best Regards and most appreciated andy.muller10@yahoo.com

Hello dear friends and fellows around the world. As you may kindly know there is a table including all the electronic errors/faults (an alphabet letter combined with two digits. Eg: G31 etc.) in manual and defines what they means. I have lost this concerned pages. So would you please send me...

Hello Friend, To set the machine at straight mode: I repeat again: This is a mechanical (manual) act. Also there is Pedestal (at drive-side, under the cover frame) which is using by foot to disengage the main motor brake, while you are rotating the machine. that MUST be used in this process (at...

They are from the Main Cabinet SM74-2-P with Compact CP tronic. four photos

Hello Dear Friend, Adil Thank you very much in advance for your kind help and feedback. This press is at customer sight. Photos from main cabinet have been attached. Thank you very much again for your help

Hello Dear Friend As Adil already said this is not a complicated process. But you should take a little bite attention to do step by step = To put your Press at straight mode. While machine is ON just make sure that manually your press is on straight mode if not so then for this purpose you have...

I am speaking about the ripple current this is why lots of big capacitors are on Press on each electronics boards Measuring ripple current with an oscilloscope can be a bit tricky because oscilloscopes usually measure voltage, not current directly. However, wish you good luck coming soon

just curiosity : Have you ever try to do hard-reset (on the x11 (Male pins) a pair of jumpers connect between 9-10 and connect between 11-12 )? Is this possible if you swap or exchange the MTN board with a correct and reliable one?

This device is not responsible for internal failures but it is using for monitoring the earth and leakage currents. first of all do it bridge and continue your investigations. I have already had the same condition on an OLD PM52. it was hanging and getting stock at start-up logo and I have...