Recent content by Alistair Tinsley

It is just a 3 plug connector. I am thinking that because it's continues to beep no matter what side I Register that the problem is the sensor in the middle.Could this be the case? Thankd

Where is the control box for the sensors?

Hello all. Fault with PM 74 registration. Mechanically it is registering 100% but it still continues to beep. This happens no matter what side you register. Checked sensors both sides (clean etc) and all seems fine. What are the likely causes of this? Help appreciated Thank you

My first job on a new folder gluer. Rolam GS 800 I have job setup okay and folding but trouble with feeding as job quite small in centre. 60 mm in centre .It twist so easy in feeder. Using 2 stops at feeder postions marked in red. Tried positions 1 but will not feed continuously straight. What...

Hello Thank you for replying. I understand what you are telling me But if I replaced the valve block marked x with the 4 way cross and put a tap control on outlet to machine marked red arrow would the circulation work ? Thanks

Hello Thank you for replying Details on photo Thank you

Thank you Does the water control valve do anything special or would a 4 way T cross fitting do with a tap on the outlet? Would that work? Thank you

Need water Speen controller block. Pipes got broken of and blocks cracked. Need replacement parts. Anyone have any idea where to go to look bits Photo attached Thank you in advance

Don't use alcohol ,just fount solution and water

Okay Thanks. I find control / supply of water very hard to balance. This is roller. What you reckon is the most important roller. Do you thing its more a foundation solution reaction other that mechanical. Rollers have all been checked. Thanks A

Hi But what details would you need.The water pours out of the unit from the damping section when unit is printing. Thanks A

Hi Guys. Do any of you guys have trouble with water dripping out unto tray then it filling up and then down into machine. It's a pain to control . I have taken rollers out reset ,checked pressures ,made sure everything operating correctly which it seems to be but it still persists.Its not the...