Recent content by affromonkey

Hi Guys, Just had like 4 days of down time for this one too! absolute ar*e of a problem on the igen 150. Engineers had all sorts of ideas, had an STS in and then finally had a fix. The print was about 20-30mm offset in process direction so we had the chevrons on the page! Other annoying thing...

no nothing to do with different stocks, as in i print all variable data, in sets of about 1k A4's per file either single sided or double sided. each job is say 10k. so 10 files exactly the same setup, same stock, 3 up on 320x660mm 100gsm smooth uncoated. Then i set it to do 2 or 3 files to the...

Hi guys, i have like 100K sheets to print, and after every file that is about 334 sheets that are sent to the stacker, the igen just pauses, and then starts again like 2 mins later. i need every minute i can get, so why the f does it pause all the time. It really annoys me... it's always done it...

Hi Guys, Any ideas on how to increase the fuser web speed on a 150? There are lots of NVMs for the fuser web and i don't want to screw anything up. Just a temporary measure for 5-6k sheets or so. also any do's or don'ts when messing with the speed? Thanks, Charlie

Hi flangmasterj, What specific xerox sheets were you running? the Colortech or Colour Impressions? thanks, affromonkey

This is 100% xerox guaranteed by the Europe RML, and is a good quality silk stock. below link is what i was sent to by an engineer, it did make me laugh it was a post on here! http://www.colorprintingforum.com/xerox-iGen/rub-off-silk-coated-stock-5977.html

i did the contact arcs (fuser and pressure roll) to start with, one of the first things i did when i changed the fuser early on in the process. between fuser and the two ext heat rolls i'm not sure is the answer, but i think that was one of the things they check earlier, as they double checked...

now i'm told, thats just how silk stock. been running iGens for 7 years now... can't say i've really noticed it, so news to me! also can't say that's in the customer expectations doc or as a caveat when being sold igens.

still no better after engineer changing all thermisters. Please help!!!!

Hi Guys, Basically i am running 300gsm silk stock, 100% guaranteed by xerox SRA3 or XXL on igen 150. and when it comes out the stacker there are traces of toner on the sheet above. I then go to knock it up with no excessive force and more toner comes off onto the sheet above and makes it...

Thanks Mark, support on phone said the same thing, so decreased to 4.7 then changed charge station, wire mod and scorotrons. the only reason I increased it was I had a tech note from about a year and a half ago saved on the desktop that said to increase it. So no wonder it didn't make it any...

Example Example next to barcode and address