Recent content by Adil

good job

rek2 or rgp

hi sir you must send me init test and dyn test to see hexadecimall error code thank you

cpc com FFFE mean fhat the communication between bek and rek 2 is lost ggood luck

if ypu have a scrall star from heidelberg that s good or you can work with ordinary compressor 3 or 4 kw

check the ipc battety voltage , change it if you did not find 3v

It could be a stretching issue, not a misalignment, and it could be due to the underlay, the fiber direction, or something else. But please confirm the questions I asked so I have all the information I need for the diagnosis.

Please give me the color sequence and which group it belongs to? Does the guide extend only to the gripper point or also to the end of the sheet? Do you print one pass or two?

If you simply have a problem with the placement of the components and zeroing, then there's a procedure to do it from start to finish. It's not difficult, but it can be done step by step.

First, you must check if there is any blockage in the adjustment screws in the inkwell segments, and then adjust the zeroing.

Do you have any errors to mention regarding the servomotors of the inkwells?

It could be a problem with the oil seals on the oscillating rollers.

Test the communication cable between the CPC and the machine. Also, try disabling the SFK card and connecting it directly to perform a diagnostic process of elimination.

Hello Synil, On the SORM, the pressurization in the first group is done using an electromagnet, but the second group is synchronized mechanically with the first group. You should check an adjustment rod; sometimes its tightening nut shifts, or you might have wear on the mechanical components.

Be welcome