SM 74 no air

Discussion in 'Heidelberg Printing Presses' started by mark vanes, Jun 15, 2015.

  1. mark vanes

    mark vanes Member

    Joined:
    Jan 2014
    Messages:
    30
    Location:
    Qatar
    red light showing & error symbol for insufficient pressure.
    Compressor is ok for some reason sensor not allowing valve to open.
    Any ideas ?

    mark
     
    mark vanes, Jun 15, 2015
    #1
  2. Waqas_zahid

    Waqas_zahid Senior Member

    Joined:
    May 2011
    Messages:
    234
    Location:
    Pakistan
    Hello Mark,

    Can you look at the current output of the pressure transducer on the display screen? If the pressure is ok the current output should be around 18mA, in order to remove the error and confirm the sensor is faulty you can install a potentiometer in place of the sensor and adjust it to point where the error is removed.
     
    Waqas_zahid, Jun 15, 2015
    #2
Loading...
Similar Threads
  1. old school 52

    Durr-Technik air compressor

    old school 52, Dec 17, 2023, in forum: Heidelberg Printing Presses
    Replies:
    6
    Views:
    537
    old school 52
    Dec 28, 2023
  2. Amos Mashonga

    Air supply cabinet

    Amos Mashonga, Dec 13, 2023, in forum: Heidelberg Printing Presses
    Replies:
    5
    Views:
    738
    Adil
    Dec 25, 2023
  3. ali 120

    Can this motor be repaired since it is not working?

    ali 120, Dec 9, 2023, in forum: Heidelberg Printing Presses
    Replies:
    2
    Views:
    503
    Good_part
    Dec 13, 2023
  4. printerscd

    Problem on AIR CONTROL

    printerscd, Oct 12, 2023, in forum: Heidelberg Printing Presses
    Replies:
    5
    Views:
    651
    Adil
    Oct 13, 2023
  5. pressmachines

    Grafix IR Dryer GSTA Contoller Repair please refer

    pressmachines, Mar 24, 2023, in forum: Heidelberg Printing Presses
    Replies:
    1
    Views:
    695
    er.bajaj001@gmail.com
    Mar 24, 2023