X2f-08-3115

Vertical Transports Motor Power Saturation
Any Fix?
iGen 150
Keep Being Told Because it's too cold.
But Then Again The Fault Doesn't Go Away At All...

 

Check the rolls. Do they have flat spots or are they soft? Are they yellow or black rolls? Never mind saw if was a150. Check the drives in the back. Turn by hand to see if there is any binding.

 

I have a iGen4 with the same faulty code 08-3115, any any Idea??? I don't see any poss about this code, Thanks.

 

Check feeder areas for undetected jams, any paper stuck between sensors. If you had any jams where the paper ripped when you took it out you could have a bits jammed into a roller wheel causing the motor to over-drive (power saturation).

Or the drive motor is just shot.

 

ive gotten errors just like that "motor power saturation" in different areas, though. and it was after a really bad jam. I remember power cycling, then reseating any wires going to motor and nearby sensors. and never seen again.

if it continues, and there's no obstructions... Im with cargo. fried motor.