WP 115 Wohlenberg Backgauge problem

Discussion in 'Cutters and Trimmers' started by adnan azzam, Aug 30, 2018.

  1. adnan azzam

    adnan azzam Member

    Joined:
    Jun 2018
    Messages:
    13
    Location:
    Damascus
    Hi every one hope all u ok
    I have problem with wohlenberg MCS2 cutter when we switch on the cutter and go to reference point the cutter give 510 and around and the backguage goes forword but not move back word until turning off and on again

    any advice for help
    thanks
    Adnan Azzam
     
  2. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    1,151
    Location:
    Managua,Nicaragua
    Hi sir
    Attached you will the schematic of limit swtich
    that you must test and check,in the table.
    1)clean it contact 2) tight wires loose 3) Test the voltage is there at switch 4) Tight the limit the Bolts if there are loose 5)clean
    from any Oil, grease, etc.
    Let me know
    Blessing
    superchock@yandex.com
    cel+WhatsApp:+505 88611441
     

    Attached Files:

  3. Scopesys

    Scopesys Member

    Joined:
    Dec 2014
    Messages:
    33
    Location:
    East Coast USA

    Most likely cause: Defective Siemens COUNTER Chip .
    Plug in IC, easily changed, not so easily found for sale,
     
Loading...

Share This Page