Water Mark on the image area

Dear members,

I am facing problem that water line showing in image area , I have checked reduced the water level , but not going ,
Please .

 

Dear Raman
First of all you have to check your rollers condition, and adjust them as recommend by your manual.
Then use a good quality of fountain solution and Alcohol, dose them according to the manufacturer.
Good luck.

 

hi dear brother, disassemble the doser and see the adjustment between the moistener and degreaser.

 

Dear sir,
All the unit rollers are not new rollers, and we don't have new rollers with us, have to manage with the rollers which we are fixed, and I have set the rollers according to the manual.
I will check the dampening solution to refresh it.
Thanks

 

Dear sir,

I didn't understand the mentioned words, please can you explain the rollers name in dampening unit.
Thanks.

 

Dear sir,
In that inking unit, have only 3 form rollers,1 st form rollers don't have , this will affect to create water line because of loss of ink supply from 1 st form roller?

 

Please can I know what type of machine you had and please can I see a picture of your mooring system to better explain it to you since you do not understand my thank you cordially.

 

CD 74 2003 model

 

I think it would be quite important to have the recommended amount of rollers in the ink train to ensure correct ink / water balance.
The 1st 2 plate inkers (after the dampers) carry the most amount of ink going onto the plate & therefore ideally should be in the press.