VPP motor stopping in indigo 5000 feeder

Discussion in 'HP Indigo Digital Presses' started by Raju, Aug 31, 2018.

  1. Raju

    Raju Member

    Joined:
    Nov 2017
    Messages:
    36
    Location:
    New Delhi, INDIA
    Respected member of CPF.com
    Hello to everyone one
    I am facing a very uncertain problem in my 5000 feeder as the VVP motor fail to start when print command or paper transport command is given ..Then I have to rotate the motor by its belt from the back side of the feeder ...After that it starts working ...And this happens all day ....I have changed the motor but problem is same .
    Error : feeder fail to initialize for printing
    VVP motor not working
    Please help and sent your valuable suggestions here or at what's app 9810689766
    Thanks and regards
    Raj k
     
  2. Milo Wilson

    Milo Wilson Senior Member

    Joined:
    Dec 2007
    Messages:
    477
    Location:
    Arkansas
    I'm an Igen guy but usually i have seen motor stalling on startup is caused by bearings or flat paper drive rolls that are being turned by the motor.
     
  3. Raju

    Raju Member

    Joined:
    Nov 2017
    Messages:
    36
    Location:
    New Delhi, INDIA
    Thanks but it is a stepper motor with encoder ...If I open I will loose the degree
     
  4. Milo Wilson

    Milo Wilson Senior Member

    Joined:
    Dec 2007
    Messages:
    477
    Location:
    Arkansas
    I didn't mean the motor itself, I meant the transports that it turns.
     

  5. Raju

    Raju Member

    Joined:
    Nov 2017
    Messages:
    36
    Location:
    New Delhi, INDIA
    Thanks sir for your valuable advice
     
Loading...