The chain lubricator in the delivery repeatediy signals a lubrication error.

Discussion in 'KBA Printing Presses' started by Kristian123, Jul 2, 2024.

  1. Kristian123

    Kristian123 Member

    Joined:
    Feb 2022
    Messages:
    11
    Location:
    Indonesia
    Hi guys, i need your advice for my problem. My machine KBA have a noticed like this :
    "The chain lubricator in the delivery repeatediy signals a lubrication error. Possible causes are
    malfunctions in lubricant device, lubrication not switched on or too litte lubricant available
    (message 20177)"


    1. Oil level on delivery is full and the sensor oli level work properly.
    2. Relay K19 in delivery, sometimes ON.
    3. What are the conditions for turning on output PLC delivery A1:59?

    Thank you in advance.
     

    Attached Files:

  2. Mehanka Abortmaher

    Mehanka Abortmaher Senior Member

    Joined:
    Apr 2022
    Messages:
    155
    Location:
    Russia
    @Kristian123
    Disconnect the grease supply tubes from the guide rails and make sure that oil is supplied when the lubricator is turned on. Check the lubricator switch-on relay/contactor, there may be a problem in the feedback circuit.
     
    Kristian123 likes this.
  3. Mehanka Abortmaher

    Mehanka Abortmaher Senior Member

    Joined:
    Apr 2022
    Messages:
    155
    Location:
    Russia
    @Kristian123
    Our computer has a "turn on lubricator" button for forced lubrication of chains. Recently, the lubricating brushes were replaced and the feed was checked.
     
    Kristian123 likes this.
Loading...