Stock mismatch

Discussion in 'Xerox iGen3, iGen4, & iGen5 Digital Presses' started by peels, Jan 27, 2017.

  1. peels

    peels tree killer :)

    Joined:
    Dec 2010
    Messages:
    1,113
    Location:
    southeast iowa, usa
    cant use my feeder A1 upper. wont recognize any paper size, never raises. just goes straight to "stock mismatch"

    didnt do anything, just changed to a new size after the repair of the interlock, and reboot.

    never had one of these feeders apart. Im assuming theres a position sensor that gone or something? but i dont see anything. lol just take off the tons of screws on the tray, and look beneath?
     
  2. HJTECH_GJS

    HJTECH_GJS Member

    Joined:
    Dec 2016
    Messages:
    25
    Location:
    Montgomery, AL
    @peels I just had the same issues this morning around 9:00 am and I just did a restart and that fixed the stock mismatch issue. Machines have a mind of their own...
     
  3. peels

    peels tree killer :)

    Joined:
    Dec 2010
    Messages:
    1,113
    Location:
    southeast iowa, usa
    didnt get that lucky this time.... :( no matter the size, it clicks on, then right back off, with green "unlocked" light...never raising.
     
  4. Milo Wilson

    Milo Wilson Senior Member

    Joined:
    Dec 2007
    Messages:
    477
    Location:
    Arkansas
    You wouldn't be trying to run short edge feed would you?
     
  5. peels

    peels tree killer :)

    Joined:
    Dec 2010
    Messages:
    1,113
    Location:
    southeast iowa, usa
    nope. size is irrelevant. does it short edge, long edge, and even 14x18

    one of those guide rods below the drawer feels loose so I wonder.... I might mess with it tomorrow.
     
  6. peels

    peels tree killer :)

    Joined:
    Dec 2010
    Messages:
    1,113
    Location:
    southeast iowa, usa
    FIXED.

    the tech that quit Xerox to work for us stopped by. Reminded me about re-setting the feeder at the board(little button) then reboot.. Id forgotten about that.

    easy peasy, lemon squeezy.
     
  7. Laserdrucker

    Laserdrucker Member

    Joined:
    Jul 2009
    Messages:
    6
    Location:
    N/A
    Feeder MCON Reset Button

    For the new and uninitiated...:)
    Feeder MCON Reset.jpg
     

  8. peels

    peels tree killer :)

    Joined:
    Dec 2010
    Messages:
    1,113
    Location:
    southeast iowa, usa


    yep! awesome, thanks for the pic!
     
Loading...