SM102 Motor Problem

Discussion in '4-Color Offset Presses +' started by micsabri, Dec 5, 2022.

  1. micsabri

    micsabri Member

    Joined:
    Sep 2021
    Messages:
    48
    Location:
    Singapore
    My motor just overhauled/rewinded, but appeal this problem after installation. Can someone here know what is going on? Thank you very much.
     

    Attached Files:

  2. ashok kumar

    ashok kumar Senior Member

    Joined:
    Nov 2017
    Messages:
    224
    Location:
    india
    It's break problem, if you know how to clean/tight break then do the same other call motor mechanic he will do
     
  3. Adil

    Adil Senior Member

    Joined:
    Nov 2021
    Messages:
    856
    Location:
    Casablanca
    Hi sir
    due to the braking, dust accumulates at the level of the brake which can cause slippage which stops the machine giving an error message.
    in your case as said ashok you have to dismantle the brake and clean it (blow with compressed air) then grease the springs and reassemble it if the machine is cptronic.
    but if you have a machine with cp2000 there is a procedure to do after dismantling the encoder and brake.
    Good luck
     
  4. micsabri

    micsabri Member

    Joined:
    Sep 2021
    Messages:
    48
    Location:
    Singapore
    Thanks, we have checked however is board problem. Thank you.
     
  5. Adil

    Adil Senior Member

    Joined:
    Nov 2021
    Messages:
    856
    Location:
    Casablanca
    it was necessary to give us the dyn test to be able to locate the problem but these recommendations that I gave it is a basic maintenance of the brake and if it does not work you can examine the electronic control part
     
  6. micsabri

    micsabri Member

    Joined:
    Sep 2021
    Messages:
    48
    Location:
    Singapore
    Noted, tq sir
     

  7. Adil

    Adil Senior Member

    Joined:
    Nov 2021
    Messages:
    856
    Location:
    Casablanca
    Did you find a problem on BAK card ??
     
    Last edited: Dec 9, 2022
Loading...