Sm102-4

I am concerned with that, the zeroing is not done so the sound signal is only sounded.
here is the information on the desk.

 

As you are probably aware, the delivery chain and jogger lubrication are well past their programmed interval. Inspect thermal overload and plug connections. It's been the case at times, printers have not used the proper flow grease, and mixed incompatible types, creating an immovable sludge within the system.

 

Hello,
First check the grease pump (under the grease container) at delivery DS (drive side), it should start turning after the machine startup and before the error sound.
If it is not running, check the circuit breaker in the main cabinet.
If it is running, then check the sensors on the grease distributer (near the pumb).
One of them has to be faulty.

 

Dear sir, seems I am facing the same problem. Can I know where is the "programmed interval"? In the board? Which board?

 

Dear sir, yes all sensors checked, motor pump working until overload to delivery chain and jogger side.

 

I don’t have the information on how to change programmed intervals. That would have no bearing on resolving this issue, anyway.

 

Sir
As per the pix you grease lubrication (1) is not done you have to reset the same
Procedure put the machine in slow running (3k rpm) and activate the sensor (1) for 3times with interval of 3sec on 3 off
In the same way reset the second sensor also
Now grease button will be come