Sm 74 all my servo motor blinking mean not working

Discussion in 'Heidelberg Printing Presses' started by Freddie123, Dec 26, 2019.

  1. Freddie123

    Freddie123 New Member

    Joined:
    Feb 2019
    Messages:
    2
    Location:
    Sudan
    My Ssk2 red lamp not on thus it mean I have problem on card cause my servo motor blinking not working on cptronic
     
  2. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,852
    Location:
    Managua,Nicaragua
    Hi :
    Normally when this happen,
    1) is status of lack of voltage to the servo motor, or connection loose, broken, or dirty or corroded,
    2) Pot dirty, or loose wires, or defective.
    3) Or servo motor defective, try to exchange with another that is working, a test it.
     
  3. Waqas_zahid

    Waqas_zahid Senior Member

    Joined:
    May 2011
    Messages:
    234
    Location:
    Pakistan
    Try turning ON with just One SSK board, try all the boards individually till you isolate the board with the problem.

    If the SSKs dont work individually and the red light still does not come ON the problem might be with your SAK board (or the cable in worst cases), no blinking red light means no communication to the SAK
     
Loading...