Ryobi 524HXX Sofware issue

Discussion in 'Ryobi Printing Presses' started by ganeshkla, Mar 14, 2018.

  1. ganeshkla

    ganeshkla New Member

    Joined:
    Mar 2018
    Messages:
    1
    Location:
    Uganda
    Hi,
    I have a peculiar problem. I am using a Ryobi 524 HXX with PCS-H console. The display above the delivery pile says "Could not connect to host". My technician said that it could be a battery problem. We got a new battery and changed it. But now the Ryobi technician is saying that it is a memory problem and probably will need to get a new software compatible with the machine. And the price sounds crazy. Any body who has faced similar problems? Any solution? It would be great if someone could really help.

    Regards
    ganeshkla
     
  2. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    1,058
    Location:
    Managua,Nicaragua
    Hi sir
    Normally you must test the power supply if o.k, and withing the tolerances.
    The battery must be for Lithium with 3.3Vdc, other is NOT o.k.
    See if there are some connector or flex cables, or ribbon cables, loose, or dirty and clean with Electronic Spray control, the
    same with pin for IC. Resolder the MOBO, (motherboard) .
    Blessing.
    superchock@yandex.com
    cell+whatsApp:+50588611441
    Managua, Nicaragua
     

    Attached Files:

  3. PARASURAMAN

    PARASURAMAN Member

    Joined:
    Sep 2017
    Messages:
    8
    Location:
    New Zealand
    Hi Its loose contact somewhere just check properly the wiring....connections I have dismantled few and have even installed sometimes due to loose contacts it does...recently I had sold one 524 HX ext delivery to India local Engineer had fixed no worries....
     

  4. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    1,058
    Location:
    Managua,Nicaragua
Loading...

Share This Page