Ryobi 3302 sticks on impression

[denningmp3]

hello hope someone has had this problem and can help, basically the press stays on impression when the paper feed is stopped. it is the second unit that is doing this it leaves an image in one face of the impression cylinder please help

 

[Printerforlife]

This is a dirty sensor Clean all sensor the problem will go away. Good luck

 

[denningmp3]

Did that turns out it was a sticky solenoid thnx though

 

[ziggy33]

Yup i was gonna say clean your solenoids they tend to stick after awhile and are slow to release impression. glad its working for ya

 

[satsoomer]

I have a similar problem on a 512H, are the solenoids on the control board or on the press near the impression cylinder?

 

[denningmp3]

On the op side frame there are two, one for each unit

 

[denningmp3]

sorry yes they are near the impression cylinder some times oil will get inside. I just pulled the plunger out and cleaned with alcohol good as gold

 

[superteto]

contact me:ercupa@netscape.net

superteto

 

[Offset George]

Solenoids get oil in them and should be cleaned periodically. Our press would pull off impression late so we knew it was time for cleaning. I f there was a missfeed or you disengaged feeder the one head would print on the impression cyclendar what a pain. It would generally happen when the press had been running for awhile..Pull the top side covers off and they will be one for each head..