Ryobi 2800 Feed Pile Adjust After Rebuild

Discussion in 'Ryobi Printing Presses' started by sed, Jul 5, 2017.

  1. sed

    sed New Member

    Joined:
    Jul 2017
    Messages:
    2
    Location:
    Ford City, PA
    Anyone have a service manual with adjustment procedure after a feed pile rebuild?
    Just replaced the pivot indicator and feed pile bail lever and now having issues.
    Did not replace the spring or fine adjust joint as they seemed OK.
    Pile height stops for a while, then keeps rising. Eccentric stud not set correctly?
    Have been playing with no luck. HELP!!
     
  2. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    443
    Location:
    Managua
    Hi sir
    Good day
    Is the machine have limit switch or sensor?
    Maybe if have, try to test with the schematic diagram
    However you must see, if the mechanical parts are o.k or to waste or really Not adjust according
    Let me know.
    Blessing
    superchock@yandex.com
     
  3. sed

    sed New Member

    Joined:
    Jul 2017
    Messages:
    2
    Location:
    Ford City, PA
    Its purely mechanical issue.
    Got hooked up with a guy w/service experience.
    Should have issue resolved on Monday. Thanks anyway.
     

  4. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    443
    Location:
    Managua
Loading...

Share This Page