R300 - Clamp Error 61(Over Current)

[thunderbird press]

intermittent issue where I would get this error during plate clamp and release.

took out the entire CPL unit, moved chains off the sprockets and tried to move from console.

motor would just move for a half second in either direction.

Milwright has taken motor apart and confirms it is not binding or damaged.

Any other ideas?

 

[thunderbird press]

Also, does anyone know if I would need to reset my petentiometer if im getting over current issues?

 

[drukman]

Ee.

 

[Daniel.Sanchez]

Change potenciometer

 

[thunderbird press]

Change potenciometer

how do i eliminate if the potentiometer is the problem? we switched the secondary head and it still had the same motor error where it just jerks.

 

[Asim Shehzad]

how do i eliminate if the potentiometer is the problem? we switched the secondary head and it still had the same motor error where it just jerks.

calibrate the system with program 2 if you have successfully done otherwise system must be calibrated with CPL tools disk

 

[drukman]

Replace the potentiometer (if defective), the motor, (if defective) and adjust as I have shown above. There is no other way.

 

[thunderbird press]

ok, anyone know of someone here that sells used for cheap? I've gotten a quote from daniel.sanchez and his price is closer to man roland new.

 

[thunderbird press]

Replace the potentiometer (if defective), the motor, (if defective) and adjust as I have shown above. There is no other way.

also, how do I figure out which one is broken? because my motor kind of moves(like quarter inch)

 

[Daniel.Sanchez]

Send one video with cpl tools

 

[thunderbird press]

fixed by replacing clamp motor

 

[Daniel.Sanchez]

fixed by replacing clamp motor

Good