Quick Master Roller setting instructions

I am trying to set rollers on a quickmaster 2010. setting screw colors in manual do not correspond to this press.
I have
yellow - distributor setting
Blue- distributor setting
Red- Distributor setting

silver-plate setting
Orange- Plate setting
Pink- Plate setting
I do not have Purple or Lavender screw heads.
I cannot figure which plate setting is the #2 roller plate color, book says purple. (No Purple) Should be set first.
Anyone have a setting diagram?
Thanks

 

blue->red->yellow 4mm
blue-> pink
yellow->orange
red->silver 3mm

 

I am sorry realaqu I do understand what you are telling me.

 

Figured out the problem. roller carriage was hanging up on the operator side. Once freed everything went ok. Still don't have a purple or lavender screw, mine is pink instead of purple or violet.

 

According with the operator manual Heidelberg QM 46 here the details:

The markings of the adjusting screws:

The 1st inking form roller is orange

The 2nd inking form roller is violet

The 3rd inking form roller is silver

Repeat the procedure until the ink strips are of the required width (3 mm) .

Good luck

Blessing

 

Thanks Chock, your always helpful.