proof 1 then run the job and colors dont match!!

Discussion in 'Xerox iGen3, iGen4, & iGen5 Digital Presses' started by swifty, Nov 8, 2012.

  1. swifty

    swifty Senior Member

    Joined:
    Sep 2008
    Messages:
    69
    Location:
    Arlington Ma.
    I was wondering if anyone else has run into this one
    Do 1 proof..check color,reg. etc.,30 seconds later Release the job and the color is
    not a match too the proof!!! does not matter what stock ? New PR belt,new fuser roll,.pres. set at 14.5. New wire mods, grids etc etc
    no pattern or reason,just all of a sudden happens. do a re-start and all is well:D
     
    swifty, Nov 8, 2012
    #1
Loading...
Similar Threads
  1. RMiGen

    Proofing

    RMiGen, Nov 9, 2010, in forum: Xerox iGen3, iGen4, & iGen5 Digital Presses
    Replies:
    2
    Views:
    2,159
    RMiGen
    Nov 9, 2010
  2. Darla

    Running night shift sucks

    Darla, Mar 11, 2021, in forum: Xerox iGen3, iGen4, & iGen5 Digital Presses
    Replies:
    4
    Views:
    1,348
    Darla
    Mar 24, 2021
  3. Adam Garnsey

    Question for people running 14 x 26 stock

    Adam Garnsey, Mar 22, 2019, in forum: Xerox iGen3, iGen4, & iGen5 Digital Presses
    Replies:
    0
    Views:
    1,014
    Adam Garnsey
    Mar 22, 2019
  4. banjoman

    long full color runs

    banjoman, Apr 12, 2016, in forum: Xerox iGen3, iGen4, & iGen5 Digital Presses
    Replies:
    3
    Views:
    1,804
    kingpd@businessprints.net
    Apr 27, 2016
  5. Kiran04

    iGen3 Free Flow Auto Color Quality won't run

    Kiran04, Jun 23, 2015, in forum: Xerox iGen3, iGen4, & iGen5 Digital Presses
    Replies:
    5
    Views:
    2,940
    Kiran04
    Jul 15, 2015