problem with starting QMDI Plus with idle state button

Discussion in 'DI Presses' started by ahmedmaher74, Oct 1, 2016.

  1. ahmedmaher74

    ahmedmaher74 Member

    Joined:
    Sep 2016
    Messages:
    37
    Location:
    United States
    Dears, when i try to run the machine with idle state button it starts for less than a second and then stops again. also when i try to inching from OS or DS it stops and hang (freeze) until i have to restart the machine again.

    you can look at the videos in this links..

    https://youtu.be/ZrnmkuQ1XWU

    https://youtu.be/s7dlIA2UNPs


    any advices please..
     
  2. Risu

    Risu Senior Member

    Joined:
    May 2012
    Messages:
    109
    Location:
    Finland
    Check error codes: S 56
     
  3. ahmedmaher74

    ahmedmaher74 Member

    Joined:
    Sep 2016
    Messages:
    37
    Location:
    United States
    Thanks Risu, it was cable loose between the machine and console. Solved

    But today when it was running on idle state after imaging the plates to prepare for the job I presses by mistake on the button has 4 zeros beside the screen and then the machine stopped after a second giving error 12-11 which is sheet lost in between the impression cylinder and delivery chain, I checked but didn't find anything.. I got the vacuum and cleaned this area very well but still giving same error. Do u think pressing this button while in idle state running is the cause of this issue or it's by chance in same time and what do you think the solution for that. I spent three hours to get a solution but None.

    Advise please.. thanks
     
  4. Risu

    Risu Senior Member

    Joined:
    May 2012
    Messages:
    109
    Location:
    Finland
    Did you clear the error code with S 11?
     
  5. ahmedmaher74

    ahmedmaher74 Member

    Joined:
    Sep 2016
    Messages:
    37
    Location:
    United States
    Yes cleared after I cleaned the sensor underneath the cylinder ... now up and running ...
     

  6. ahmedmaher74

    ahmedmaher74 Member

    Joined:
    Sep 2016
    Messages:
    37
    Location:
    United States
    Many Thanks Risu .. you are very supportive..
     
Loading...