Presstek 52DI recommended cylinder pressures

Discussion in 'DI Presses' started by cmcfarling, Dec 9, 2009.

Tags:
  1. cmcfarling

    cmcfarling New Member

    Joined:
    Dec 2009
    Messages:
    3
    Location:
    USA
    According the 52DI manual the blanket should measure 0.1mm over the bearer. The manual shows the plate being 0.178mm thick but it doesn't spec the plate cylinder undercut. How much over the bearer is the plate cylinder? Also then, what is the recommended plate to blanket squeeze?

    Am I correct in thinking that this press is a non-bearer-contact press (blanket to impression cylinder bearers do not touch)?
     
    cmcfarling, Dec 9, 2009
    #1
  2. cmcfarling

    cmcfarling New Member

    Joined:
    Dec 2009
    Messages:
    3
    Location:
    USA
    meant to say...

    non-bearer-contact press (blanket to plate cylinder bearers do not touch)
     
    cmcfarling, Dec 16, 2009
    #2
Loading...
Similar Threads
  1. enyaw 1987

    Presstek 52DI

    enyaw 1987, Jan 6, 2022, in forum: DI Presses
    Replies:
    0
    Views:
    963
    enyaw 1987
    Jan 6, 2022
  2. vanceibz

    Strange problem with Presstek 52DI. Urgent Help Required!

    vanceibz, Jul 11, 2019, in forum: DI Presses
    Replies:
    2
    Views:
    1,904
    vanceibz
    Mar 18, 2020
  3. Juice780

    Presstek 52di

    Juice780, Oct 7, 2017, in forum: DI Presses
    Replies:
    1
    Views:
    1,477
    CHOCK
    Oct 7, 2017
  4. jetdisplay

    Presstek 52DI Part

    jetdisplay, Nov 22, 2013, in forum: DI Presses
    Replies:
    5
    Views:
    3,079
    jetdisplay
    Nov 27, 2013
  5. tim enigma

    Presstek 52DI-AC

    tim enigma, Oct 17, 2011, in forum: DI Presses
    Replies:
    2
    Views:
    3,048
    BWolf
    Oct 18, 2011