Polar MOHR 115CE cutting machine knife not stoping after one cycle

Hello Engineers,

Need Help.

First time attending this problem. pls help me.

This Polar MOHR 115CE cutting machine knife not stoping after one cycle.

This hydraulic clutch not disengagement after one cycle.

Is it mechanical or electrical problem?

Thank you.

 

Hi Sir:
Hope you are well.
You have Mechanic Problem.
Attached is there the Gear Limit switch for Polar 115 CE that you send us.
The cutting button pressed, the knife must will only carry out one cut, and must stop and the
upper dead point.
The next cutting cut is ONLY possible after releasing both cutting buttons.
Adjust limit switch in such way the air Gap o.1 mms remain between the plunger of the limit switchs
and the lower parts of cam, after adjustment tighten fastening screws.
Finally if is necessary the Gear cam plastic, must be adjusted too in order
the knife must will only carry out one cut, and must stop and the
upper dead point.