Polar 92 E, Error 810- backgauge motor overheated

Discussion in 'Cutters and Trimmers' started by grafische, Oct 10, 2017.

  1. grafische

    grafische Member

    Joined:
    Mar 2015
    Messages:
    16
    Location:
    Austria/Vienna
    Dear all,
    does anybody have experience with the Error Code 810 'backgauge motor overheated' on the Polar E Series. The machine is working half a day then the error appears and can not be cancelled.
    Next day in the morning the machine is still working normally until the error appears again?
     
  2. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    570
    Location:
    Managua
    Hi sir
    Good day
    The problem is the backgauge motor is Overheated.
    The reason is the thermocouple show excesive operating temperature of the motor
    1)Test the backgauge motor +thermocuple.
    2)Test the driving mechanism,spindle,sledge guiding.
    3)PCB SAP defective, replace it.
    4)Test the adjustment of frecuency converter.
    5)check cables/plugs in connections.
    Use the schematic diagrams
    Let me know any question or doubt or send me email
    Blessing.
    superchock@yandex.com
    cell+WhatsApp:+150588611441
     
Loading...

Share This Page