Polar 76EM error 83

Discussion in 'Cutters and Trimmers' started by jorjh, Nov 20, 2016.

  1. jorjh

    jorjh Member

    Joined:
    Nov 2016
    Messages:
    6
    Location:
    Romania
    Hello, we have a recently bought Polar 76EM, and after a couple of months of working perfectly it started giving an error 83 and we can't find any info anywhere regarding this. Everything works fine after startup, but the moment you press the buttons to engage the knife, it stops and the dispaly flashes 83. Does anyone know what could be the cause and the solution?
     
  2. NimeshSilva

    NimeshSilva Senior Member

    Joined:
    Jan 2013
    Messages:
    246
    Location:
    Sri Lanka
    Hi,
    I believe your machine has no light barriers, right? But the control circuitry had designed to connect a light barrier. So that there is a small device called "light barrier simulator" is connected to the back panel board to simulate the function of the light barrier. It seems you have a problem with it.

    You have to remove the back cover under the table and it is on your right hand side lower corner. A small black box. Before do anything, you pull it out and plug back in several times. That way you clean any corrosion on the pins. If that doesn't help, the simulator itself might be damaged. The only way to confirm it to move it to another machine and check it out. It can be any machine in the EM/EMC II series. And if you find it good, then you have a problem with the HK card.

    Hope this helps.
     
  3. jorjh

    jorjh Member

    Joined:
    Nov 2016
    Messages:
    6
    Location:
    Romania
    Hello and thank you for the response. It's an 1986 76em, it has the light barriers. We have taken the light barriers off and tested them on another machine, but they work fine. The machine we tested it on is the one with 99 programs and ours has 9 programs, so i dont know if the circuit boards are compatible for testing.
     
  4. NimeshSilva

    NimeshSilva Senior Member

    Joined:
    Jan 2013
    Messages:
    246
    Location:
    Sri Lanka
    ,Hi,
    They all are same. If it works fine, then you're good to go.
    Since you have already tested the light barriers (with the LS card obviously) then you have to check the cable for the light barrier (plug CU6) If it's fine, then check the HK, IAR and AR cards. And also check the flat wire harness between AR-IAR cards.

    Hope this helps.
     
  5. jorjh

    jorjh Member

    Joined:
    Nov 2016
    Messages:
    6
    Location:
    Romania
    We have tested the boards and apparently the IAR board doesn't work. Are there any connections on the board that could be checked if they work or the only solution is a new board?
     
  6. NimeshSilva

    NimeshSilva Senior Member

    Joined:
    Jan 2013
    Messages:
    246
    Location:
    Sri Lanka
    Send me your email.
     

  7. jorjh

    jorjh Member

    Joined:
    Nov 2016
    Messages:
    6
    Location:
    Romania
Loading...