Bayang Ismael
Member
- Joined
- 2024
- Posts
- 7
- Geo
- Cameroun
Hello, please, I'm actually facing a bad time with my
polar 115 XT+, we had the machine working normally
and suddenly it stopped displaying and when we turn ON
the machine, the buzzer behind the main screen keep
beeping continuously. I check the ribbon cable and the
display cable with the multimeter on continuous mode,
everything was good. I also checked and reinforced the
soldering on the CP6 and GC2 board, we still had the
same results
I checked all the voltages on the the PS board (5.04V;
12.09 and 24.03V) and I also checked the voltage on the
ADAAD board, I was 33.11V, I then got back the voltage
to 24.02V. Once that voltage on the ADAAD board was
fixed, we had the machine running but after that day it
got back to its initial fault meanwhile all voltages check
are still good and in the tolerance gap(5%).
So actually I'm completely lost and don't know what to
do next!?
polar 115 XT+, we had the machine working normally
and suddenly it stopped displaying and when we turn ON
the machine, the buzzer behind the main screen keep
beeping continuously. I check the ribbon cable and the
display cable with the multimeter on continuous mode,
everything was good. I also checked and reinforced the
soldering on the CP6 and GC2 board, we still had the
same results
I checked all the voltages on the the PS board (5.04V;
12.09 and 24.03V) and I also checked the voltage on the
ADAAD board, I was 33.11V, I then got back the voltage
to 24.02V. Once that voltage on the ADAAD board was
fixed, we had the machine running but after that day it
got back to its initial fault meanwhile all voltages check
are still good and in the tolerance gap(5%).
So actually I'm completely lost and don't know what to
do next!?
