POLAR 115 PF Error 285

[Darshana]

What could be the reason for this error 285?
Please see the picture.

 

[Adil]

Hi sir
The input signal of the mechanical reference sensor (B341) is not registered by SAP- board. The reference point (pulse) is only accepted by the computer if it is in the range of the mechanical switching flag of the reference sensor.- Make a reference run and move the backgauge alongt the entire width of the table, if the position of the mechanical reference point switch has been modified- Check functioning and position of sensor B 341- Check cabling of B341- Verify position values in service menu "machine data"

Good luck p

 

[Darshana]

Hi Mr. Adil,
Thanks for your reply.
If you have any documents with details related to this, can you share them with me?. Because I need to find the location of the B341 and SAP board.

Thanks.

 

[maverick1971]

Hi sir
The input signal of the mechanical reference sensor (B341) is not registered by SAP- board. The reference point (pulse) is only accepted by the computer if it is in the range of the mechanical switching flag of the reference sensor.- Make a reference run and move the backgauge alongt the entire width of the table, if the position of the mechanical reference point switch has been modified- Check functioning and position of sensor B 341- Check cabling of B341- Verify position values in service menu "machine data"

Good luck p

Hello Adil,

I am getting ERROR 653 on my Polar 115 ED

I have read on the forum and elsewhere on the internet that the problem is usually related to the B341 SENSOR

I have managed to locate the B341 SENSOR underneath the table.
Can you tell me where to find the actual PART NUMBER of this sensor to order a NEW ONE?

Where in the PARTS BOOK is this sensor shown?

Any assistance would be greatly appreciated.

Thank you in advance.

Kind Regards

Shawn

 

[Adil]

B341 is only the electrical designation
(not the commercial spare part name)
Look physically on the sensor body and purchase