Polar 115 PF 704

May I ask Polar 115PF error.
Is the 704 due to a clutch problem or something else?

 

Hi sir
The knife afterrun calculated by the computer is too long to ensure a safe
functioning of the machine. After this error message has been output only one
single cut can be performed at a time, for testing purposes within one switching - on
period

- Switch the machine off and on to make a check cut
- Inspect main clutch (fouled by oil, brake air gap too wide, friction value of
linings)
- Check magnetic clutch (iron air gap and / or brake springs).
- Check mechanical gear play.
- Bleed the gearbox.
- Replace the cutting circuit transformer

 

I need help with Polar 137 cutter error 132, how to fix it?

 

I need help with Polar 137 cutter error 132, how to fix it?

 

HI SIR:
Normally that means defective SK 95.

DO THIS TEST:
Press cut buttons for a longer time.
- Check SK 95- board, sensors and cabling of cutting cycle
- Check knife upstroke control, replace if necessary and connect it to +24Volt.
- Check light barrier.

 

There is a periodical display of this information while one or both side gauges are
not in their resting position.
The message is also issued in automatic operation when a cut size has been
programmed together with additional function "Retract side gauge" and the
backgauge has moved to this position. The activated automatic knife is either
switched off ormoved back to "preparation" step.
- With ED machines check switching position of SHM 95- board
- Take side gauges manually to upper resting position
- Check cabling and position limit switches of side gauges
- With ED machines check / replace SHM 95- board
- With XT machines check / replace I/O-P1- board

 

thank you very much