New Igen 5 operator

Discussion in 'Other Digital Presses' started by Michelemcl, Aug 27, 2017.

  1. Michelemcl

    Michelemcl New Member

    Joined:
    Aug 2017
    Messages:
    2
    Location:
    CT
    Can someone tell me where the etac sensors are on Igen5.....first day by myself
     
  2. peels

    peels tree killer :)

    Joined:
    Dec 2010
    Messages:
    1,113
    Location:
    southeast iowa, usa
    hey there. old post.... try putting this in the IGen sub-forum. there's a few of us other operators around to help out most of the time.... link below.

    https://www.colorprintingforum.com/community/xerox-iGen/

    to your question... ETACS. open the PR belt, they are the bottom left below the black unit. Covered by a metal shield, that must be removed to clean them. Be careful. and make sure you run dc0951 when you are done or you will likely get nasty dark prints.

    should be a good instruction in the manual.
     
Loading...