Need help ROLAND 500 error 5862

[Karo]

good afternoon friends, I'm a newbie, please help me figure it out, a problem arose during flushing, if you can, please send me a manual, a diagram of how to fix the problem.

 

[drukman]

Blast rake wrong position.

 

[Karo]

Thanks for the answer, where and how to change, I can’t find it.

 

[drukman]

This is the rake of the turner. It has 2 positions. Up when the machine is not turning and down when it is turning. Both positions are set on the motor. There is a sensor. Perform auto zero.

 

[Karo]

thank you dear friend now I will send photos and videos, it does not help auto zero
https://youtube.com/shorts/2N9mnO0c3BI?feature=share

 

[drukman]

Loosen the motor. Position the rake in the upper position (0.5 mm to the sensor). Start the machine. Clear the errors. Tighten the motor.
3 PU too many positioning errors. Check the POS2 communication board.
This is a new installation or a working machine.

 

[Karo]

working machine ,
Unfortunately I don't have a manual (scheme) at hand. Several books in German were sent with the machine but there are no schemes, maybe you have some, or you can send a photo of where they are located,

 

[drukman]

The rack is located above the turner. The motor is outside the sides.