Muller Martini 3210 Sewing

Discussion in 'Book Binding' started by KhorWK, Jul 10, 2022.

  1. KhorWK

    KhorWK Member

    Joined:
    Apr 2021
    Messages:
    46
    Location:
    Malaysia
    Hi all, I have a unit of Muller Martini 3210 but the delivery is without the controller of jigsaw. So sometimes it will cause get tie and not able to get clean cut according to number of signature. Anyone know how to overcome this issue? Thanks.
     

    Attached Files:

  2. Mehanka Abortmaher

    Mehanka Abortmaher Senior Member

    Joined:
    Apr 2022
    Messages:
    113
    Location:
    Russia
    @KhorWK , I will assume that it is necessary to loosen the overall tension of all threads, reduce the insertion of the supporting knives to 0.5 mm. if there is a groove in the crimping bar (holding the sewn notebook after the rocking table is removed), put a polyurethane/rubber cord into it.
     
  3. KhorWK

    KhorWK Member

    Joined:
    Apr 2021
    Messages:
    46
    Location:
    Malaysia
    Thank you for your guidance.
    1) Do you mean to lower down the knives to 0.5mm?
    2) My machine is like this as attached photo, do you mean to put a stick of polyurethane/rubber cord at the both left & right crimping bar?
     

    Attached Files:

Loading...