Moving Heidelberg Windmill GT 34x46

[vanceibz]

I have to move the GT and would like to lift it from the top. I have seen on the smaller versions that there is some attachment.

See photo attached. Anybody know if there is a way with the GT model? I have been looking but can see where.

Thanks

 

[Guy Rovella]

Does it have the holes for the 2" bars?

 

[vanceibz]

thanks for you response. here are some photos of the machine.. where should these holes be?

 

[Guy Rovella]

You can see the bars on top of the jack stands, front and back. Sorry for the fuzziness. It requires 2" diameter steel rods.

 

[vanceibz]

I have the front holes , but not the back ones.. does yours have also two holes there?

 

[vanceibz]

here is another photo of the back.. next to the wheel

 

[Guy Rovella]

I have the front holes , but not the back ones.. does yours have also two holes there?

Yes. You can see the bar sticking out on the left. I don't have it anymore or I'd send you a better pic.
This might help too: http://www.liontailpress.com/moving-heidi

 

[vanceibz]

thanks I will have a look

 

[vanceibz]

seems that on the GT model they covered the back holes. There front ones are still there..

The only way I can think is to lift from the front, then level with rectangular pipes..

Any better ideas?