Man Roland 202TOB major issue Help please

[elektorus]

Hi there to all good people on this forum, and hardworkers in these industry.
I have a problem with my R202 TOB. We need to check cylinders alignment and possibly adjust it. I know how it is done theoreticaly, but i do not know for this particular machine, i.e. how to manualy throw impression on and off since it has it electricaly engageing etc... so if there is so kind man here that could give me a walktrough i would be very very .....
thanks in advance...

 

[Technical_offset.pt]

hello.
what I understand from your e-mail, do you want to hit the drums.
the top with enferior.Correct?
then goes through the following:
two plates is equal. defines the edge of the "start" 5.5 or 6.0 cm.
then prints the 1st body, sets the margins.
on the motor side, you have a cover to give the diameter.
after you set the margins to the body of a print.
puts the clocks that have the motor side, with the 2nd CI position 0.
then there'll have to hit No. 1 in circumferential and then laterally.
one of the clocks goes on record, circumferential, and another in leteral.

I have helped.