Laser Plates keep breaking image

Discussion in '1-Color and 2-Color Offset Presses' started by Esteban Cuevas, Mar 28, 2023.

  1. Esteban Cuevas

    Esteban Cuevas New Member

    Mar 2023
    Bell, CA
    Hello. I'm using an ATF Chief 17 Press. I'm using Pressline DS Laser Plates. I print Laser Plates out on an HP LaserJet 5100. I'm using Universal Pink 4G case for my fountain solution. Once I put my plates on my Chief, I give it moistening of Burnishing Gold Miracle. Pretty soon on, I see the plate breaking apart. It used to be when there were big groups of solid graphics on my job. Now it can be the smallest of graphics. I even run the plate through the laser printer again to make sure it comes out extremely hot. Any ideas?

    Attached Files: