Knife Control Module Polar 115E and X

Good day,

Is the Knife control module on the Polar Mohr 115E/X the same/compatible with the Polar Mohr 78. We have a permanent cut circuit interrupted fault and I was wondering if I could use the knife control module on the Polar 115E/X on the 78 to see if this is the faulty part.

Thanks

 

Press cut buttons for a longer time.
- Check SK 95- board, sensors and cabling of cutting cycle
- Check knife upstroke control, replace if necessary and connect it to +24Volt.
- Check light barrier
- Check / replace SAP- board.
- replace Transformer TR1 (id. no. 250967)

-Check transformer cabling.