KBA rapida 104 PCON Faulty connection

Discussion in 'KBA Printing Presses' started by LUU THANH, May 22, 2024.

  1. LUU THANH

    LUU THANH New Member

    Joined:
    May 2024
    Messages:
    3
    Location:
    as
    Need help error PCON Faulty connection
     

    Attached Files:

  2. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,927
    Location:
    Managua,Nicaragua
    Hi sir:
    Normally you must review the Edge connectors from PCB, and clean with pencil eraser, and then use contact cleaner, and tigh
    very well.
    However look, for loose connectors, corroded, loose wires, broken wires, pins bent!!. and finally, if everything is o.k, look for dry and colder solder joints (reheating).
     
  3. LUU THANH

    LUU THANH New Member

    Joined:
    May 2024
    Messages:
    3
    Location:
    as
    I have tried testing the rs485 board, arcnet and communication lines for the functional parts of the machine. The communication connection boards on the machine to the other machine still work normally.
     
  4. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,927
    Location:
    Managua,Nicaragua
    Hi Sir:

    By that reason, you must follow the Steps, that I gave you before, Very important, x the Troubleshooting !.

    Good Luck.

    Blessings
     
  5. LUU THANH

    LUU THANH New Member

    Joined:
    May 2024
    Messages:
    3
    Location:
    as
    which pcb circuit board sir
     
  6. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,927
    Location:
    Managua,Nicaragua
    All PCB

    Blessings
     

  7. Koenig

    Koenig Member

    Joined:
    Jun 2023
    Messages:
    5
    Location:
    GCC
    A faulty PCON connection means the Colortronic computer is not getting a response from the machine CPU.
    - Check the RS485 serial cable connection from colotronic PC --> Machine CPU. Also, check the status of the MAWG1 (39A3 - I guess) board in the main panel. Normally, RUN, TX & RX LEDs should be responding. Also, check the status MCGR boards and of ARCnet cables.
    Try this also:
    1- Switch on the COlortronic power and don't turn ON the machine power until Colortronic computer is completely on and showing KBA machine screen
    2- Keep the COlortronic power ON and restart the machine power only.
    if it doesn't work, follow the above guide.
     
Loading...